Tekmar 480 User Switch Installation Manual do Utilizador descarregar pdf (Página 4)

Programming the User Buttons

STEP 1:

Remove the plastic trim bezel.

STEP 3:

Press and hold down the User Button until the button changes to the color of operation that is desired and then release

the button.

Red = Scene

Green = tN4 Setpoint Control Enable / Disable

Orange = Disabled Button

STEP 4

(Scene Operation, Red Flashes)

Press the User Button the number of times equal to the desired scene.

Press “User” Button Scene Red Light Flash Sequence

1 Time 1 1 Red, Off, Repeat

2 Times 2 (Away) 2 Red, Off, Repeat

3 Times 3 (Unoccupied) 3 Red, Off, Repeat

4 Times 4 4 Red, Off, Repeat

5 Times 5 5 Red, Off, Repeat

6 Times 6 (3 hr. Temporary Occupied) 6 Red, Off, Repeat

7 Times 7 (4 hr. Temporary) 7 Red, Off, Repeat

8 Times 8 (8 hr. Temporary) 8 Red, Off, Repeat

User

Button

User

Button

User

Button

STEP 2:

Press button “A” once using a blunt object to begin programming mode.

Each of the 3 User Buttons will begin to flash to indicate the current program setting:

•

• Red flashes indicate the User Button is programmed to select a scene. The number

of flashes in a row indicate the scene number.

•

• Green flashes indicate the User Button is programmed to enable or disable a

tN4 setpoint control. The number of flashes in a row indicate the setpoint device

enable number.

•

• Orange indicates the User Button has been disabled.

User

Button

User

Button

User

Button

PRESS

BUTTON

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Tekmar 480 User Switch Installation Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Transmissão Tekmar 480 User Switch Installation